\

Professional Automatic Sliding Gate opener And Motor Manufacturer For Many Years 

English

easily install your electric garage door opener yourself

by:LSDD     2020-01-07
After deciding to buy a new door opener system, you need to decide how much you can afford.
When you make a budget to purchase a new electric garage door opener, remember to include the installation cost.
Don\'t worry if you can\'t afford this extra fee;
For those who like a little bit of hands --
On DIY, it is easy to install elevated door opener.
But there are some things you should remember.
First of all, and most importantly, your garage door should have the best functionality when initially installed.
Except to find a high
Garage Door Opener quality the best way to ensure this is to clean and lubricate the hinges and internal gears of the garage door opener engine to ensure that they flow smoothly throughout the range of motion.
This will also help reduce noise levels.
So first, make sure you read the owner\'s manual for the electric garage door opener and make sure you understand it.
Take a look on the Internet;
You will definitely find helpful video instructions.
These will show you, step-by-
Steps how to easily install the overhead door opener. (
The simplest electric garage door opener to install is a chain or spiral drive opener)
Make sure you have the following items to handle when you come to install it: A good ladder, a drill bit
If you find that your garage door needs a little reinforcement, some steel plates, you can put the toolbox in.
Easy to use owner\'s manual.
When you install the overhead door opener, make sure your ladder is at the maximum height-this will negate the need for you to work on the overhead and avoid accidents.
Be careful when you install the wires-it\'s better to have a qualified electrician to help.
Make sure to manually disconnect the system in place as this will be necessary if the electric garage door opener fails or goes wrong.
Install it where adults can reach but children can\'t. First Step -
Unplug the old unit and then loosen the bolt that is fixed in the appropriate position.
Always support the unit with one hand, remove two loose bolts and gently drop the unit down.
Remove the traction bolt connecting the track to the motor.
Reconnect the new motor to the track and reconnect the chain by hand.
Be sure to adjust your garage door. While off-the-
Shelf garage door opener is usually good-
After calibration, problems with the new equipment may occur due to excessive spiral springs or under spiral springs.
It turns out that if your garage door is not well adjusted, then forget to try to install the garage door opener as a DIY project and visit the garage door professionals who can install it for you.
Since a large amount of kinetic energy is stored in the twist spring, it may be a dangerous job to adjust the spring system yourself. once you have successfully installed the overhead opener system, it may cause accidents or injuries, make sure to check the reverse system multiple times.
Put a piece of wood or brick under the door.
Now, start the electric garage door opener system to close the door.
Once the obstacle is felt, the door should stop immediately and reverse.
Be sure to make this work a few times before you finish, as this is one of the most important features of the overhead opener.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...